Venza FWD L4-2.7L (1AR-FE) (2009)
/Page-454003.png)
INSTALLATION
HINT:
-
Use the same procedure for the RH side and LH side.
-
The procedure listed below is for the LH side.
1. INSTALL DOOR SIDE AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Insert the pin (stopper) into the door hole and install the door side airbag sensor to the vehicle with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)
NOTICE:
-
If the door side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a
new one.
-
When installing the door side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
-
Make sure that the pin (stopper) is securely inserted into the door hole.
-
Tighten the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.
(d) Connect the connector to the door side airbag sensor.
NOTICE: When connecting the airbag connector, take care not to damage the airbag wire harness.
(1) Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original
position and a click sound can be heard).
Text in Illustration
HINT: When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while
connecting, as it may result in an insecure fit.
(e) Check that there is no looseness in the installation parts of the door side airbag sensor.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Reassembly
3. INSTALL COURTESY LIGHT ASSEMBLY See: Lighting and Horns/Courtesy Lamp/Service and Repair/Installation
4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver
Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Reassembly
5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger
Side) See: Sensors and Switches - Windows and Glass/Power Window Switch/Service and Repair/Front Passenger Side Power Window
