Venza FWD L4-2.7L (1AR-FE) (2009)
(a) Remove the nut and separate the rear stabilizer link assembly LH from the rear stabilizer bar.
Text in Illustration
HINT: If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud bolt.
3. SEPARATE REAR STABILIZER LINK ASSEMBLY RH
HINT: Perform the same procedure as the LH side.
4. REMOVE REAR STABILIZER BAR See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
5. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ HID Headlight System)
(a) Remove the nut and separate the rear height control sensor sub-assembly from the rear No. 2 suspension arm assembly RH.
NOTICE: Use wire or an equivalent tool to keep the rear height control sensor link from hanging down.
6. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
(a) Remove the bolt (A) and the nut, and separate the rear No. 2 suspension arm assembly LH from the rear axle carrier sub-assembly LH.
NOTICE: Since a stopper nut is used, loosen the bolt.
(b) Remove the bolt (B) and the rear No. 2 suspension arm assembly LH.
7. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
HINT: Perform the same procedure as the LH side.
8. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH