Venza FWD L4-2.7L (1AR-FE) (2009)
(b) Jack up the rear axle carrier sub-assembly LH to set the rear No. 2 suspension arm assembly LH in the tightening position as shown in the
illustration.
Standard angle (A):
4°36' (4.6°)
Standard length (B):
39.1 mm (1.54 in.)
CAUTION: Do not jack up the rear axle carrier sub-assembly LH too high as the vehicle may fall.
HINT: If the rear No. 2 suspension arm assembly LH cannot be positioned as shown in the illustration even when the rear axle carrier
sub-assembly LH is jacked up, apply additional load to the vehicle such as by having a person sit in the rear seat.
(c) Fully tighten the bolt.
Torque: 112 Nm (1141 kgf-cm, 82ft-lbf)
NOTICE:
-
Since a stopper nut is used, fully tighten the bolt.
-
The final torque must be applied under standard vehicle height conditions.
11. INSTALL REAR WHEEL
Torque: 103 Nm (1050 kgf-cm, 76ft-lbf)
12. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment See: Alignment/Service and Repair.
13. CHECK FOR SPEED SENSOR SIGNAL
(a) Check for the speed sensor signal See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial
Inspection and Diagnostic Overview/Test Mode Procedure.