Venza FWD L4-2.7L (1AR-FE) (2009)
16. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY
17. REMOVE FRONT SUSPENSION SUPPORT BEARING
18. REMOVE FRONT COIL SPRING UPPER SEAT
19. REMOVE FRONT COIL SPRING UPPER INSULATOR
20. REMOVE FRONT COIL SPRING
21. REMOVE FRONT SPRING BUMPER
22. REMOVE FRONT COIL SPRING LOWER INSULATOR
Installation
FRONT SUSPENSION: FRONT SHOCK ABSORBER: INSTALLATION
INSTALLATION
HINT:
-
Use the same procedure for the LH side and RH side.
-
The following procedure listed below is for the LH side.
1. SECURE FRONT SHOCK ABSORBER ASSEMBLY
(a) Install the bolt and nut to the front shock absorber assembly as shown in the illustration and secure the front shock absorber assembly in a vise
using aluminium plates.
A:
28 mm (1.10 in.)
2. INSTALL FRONT COIL SPRING LOWER INSULATOR
(a) Install the front coil spring lower insulator to the front shock absorber.
Text in Illustration
NOTICE: Make sure that the positioning pins on the front coil spring lower insulator are inserted into the holes in the front shock absorber.
3. INSTALL FRONT SPRING BUMPER