Venza FWD L4-2.7L (1AR-FE) (2009)
(6) Check that the D shift indicator comes on for 2 seconds.
HINT:
-
When the fluid temperature detection mode is activated, the D shift indicator on the combination meter comes on for 2 seconds.
-
If the D shift indicator does not come on for 2 seconds, return to the step where terminal TC is first connected and perform the procedure
again.
(7) Move the shift lever from N to P.
(8) Release the brake pedal.
(9) Remove SST from terminals 13 (TC) and 4 (CG).
Test in Illustration
SST: 09843-18040
NOTICE: Be sure that terminals TC and CG are not connected. If the terminals are connected, the fluid level cannot be precisely adjusted
due to fluctuations in engine speed.
HINT:
-
Disconnecting terminals TC and CG activates the engine idle control mode.
-
In the engine idle speed control mode, engine idle speed control starts when the fluid temperature becomes 35°C (95°F) or more and the
engine speed is maintained at approximately 800 rpm.
-
Even after terminals TC and CG are disconnected, the fluid temperature detection mode is active until the ignition switch is turned off.
(10) Allow the engine to idle until the D shift indicator comes on again.
D Shift Indicator
NOTICE:
-
If the D shift indicator is on, immediately proceed to the Adjust Fluid Level procedure.
-
If the D shift indicator blinks, stop the engine and wait until the fluid temperature drops to 35°C (95°F) or less (the indicator goes off).
Then perform the Adjust Fluid Temperature procedure again from the beginning.
HINT: