Venza FWD V6-3.5L (2GR-FE) (2010)
Cylinder Head Gasket: Service and Repair
Removal
2GR-FE ENGINE MECHANICAL: CYLINDER HEAD GASKET: REMOVAL
1. REMOVE CAMSHAFT
HINT
See the steps from "Remove Automatic Transaxle Assembly" through "Remove Camshaft" See: Camshaft, Lifters and Push
Rods/Camshaft/Service and Repair/Removal.
2. REMOVE NO. 2 CAMSHAFT See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal
3. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY RH See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal
4. REMOVE CAMSHAFT TIMING GEARS AND NO. 2 CHAIN (for Bank 2) See: Camshaft, Lifters and Push Rods/Camshaft/Service and
Repair/Removal
5. REMOVE NO. 3 CHAIN TENSIONER ASSEMBLY See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal
6. REMOVE CAMSHAFT BEARING CAP (for Bank 2) See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal
7. REMOVE NO. 3 CAMSHAFT See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal
8. REMOVE NO. 4 CAMSHAFT See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal
9. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY LH See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal
10. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
(a) Remove the 24 valve rocker arms.
HINT
Arrange the removed parts in the correct order.
11. REMOVE VALVE LASH ADJUSTER ASSEMBLY
(a) Remove the 24 valve lash adjuster assemblies from the cylinder head.
HINT
Arrange the removed parts in the correct order.
12. REMOVE VALVE STEM CAP
(a) Remove the 24 valve stem caps.
13. REMOVE WATER OUTLET See: Service and Repair/Overhaul/Disassembly
14. REMOVE CYLINDER HEAD SUB-ASSEMBLY RH
(a) Using a 10 mm bi-hexagon wrench, uniformly loosen the 8 cylinder head bolts in the sequence shown in the illustration. Remove the 8 cylinder
head bolts and plate washers.
NOTICE:
*
Be careful not to drop washers into the cylinder head sub-assembly.