toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Front Seat Side Airbag Assembly|Page 6818 > < Front Seat Side Airbag Assembly|Page 6816
Page 5
background image

(1) The defects are as follows:

*

Cuts on the surface and in the grooves of the steering pad

*

Small cracks on the surface and in the grooves of the steering pad

*

Significant discoloration on the surface and in the grooves of the steering pad

OK:

No defects are found.

HINT
If any of the defects is found, replace the steering pad with a new one.

(b) Make sure that the horn sounds.

HINT
If the horn does not sound, inspect the horn system  
  See: Lighting and Horns/Horn/Testing and Inspection/Symptom Related
Diagnostic Procedures.

6. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check    See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.

7. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light    See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.

Disposal

SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: DISPOSAL

CAUTION:
Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous
material regulations. Pre-disposal deployment may be considered hazardous material treatment.

1. PRECAUTION

CAUTION:
*

An airbag or pretensioner may be activated by static electricity. To prevent this, be sure to touch a metal surface with your bare
hands to discharge static electricity before performing this procedure.

*

Never dispose of a steering pad with an undeployed airbag.

*

The airbag produces an exploding sound when it is deployed, so perform the operation outdoors and where it will not create a
nuisance to nearby residents.

*

When deploying the airbag, always use the specified SST (SRS Airbag Deployment Tool). Perform the operation in a place away
from electrical noise.

*

When deploying the airbag, perform the operation at least 10 m (32.8 ft.) away from the steering pad.

*

The steering pad becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.

*

Use gloves and safety glasses when handling a steering pad with a deployed airbag.

*

Do not apply water etc. to a steering pad with a deployed airbag.

*

Always wash your hands with water after completing the operation.

HINT
When scrapping a vehicle equipped with the SRS or disposing of the steering pad, be sure to deploy the airbag first in accordance
with the procedure described below. If any abnormality occurs with the airbag deployment, contact the Service Dept. of TOYOTA

Front Seat Side Airbag Assembly|Page 6818 > < Front Seat Side Airbag Assembly|Page 6816