Venza FWD V6-3.5L (2GR-FE) (2010)
![background image](/toyota/venza_fwd/v6-3.5l_(2gr-fe)/Page-2015009.png)
(a) Install the floor end of the front seat outer belt assembly with the bolt.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(b) Check if the ELR locks.
NOTICE:
The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
6. INSTALL LAP BELT OUTER ANCHOR COVER
(a) Engage the 3 claws to install the lap belt outer anchor cover.
7. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
(a) Connect the rear door opening trim weatherstrip.
8. INSTALL REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
9. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
(a) Connect the front door opening trim weatherstrip.