Venza FWD V6-3.5L (2GR-FE) (2010)
![background image](/toyota/venza_fwd/v6-3.5l_(2gr-fe)/Page-2015040.png)
(a) Engage the 2 guides.
(b) Install the rear seat outer belt assembly with the 2 bolts.
Bolt [A] - Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)
Bolt [B] - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(c) Connect the shoulder anchor of the rear seat outer belt assembly with the bolt.
Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(d) Check if the ELR locks.
NOTICE:
The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
and Replacement/Installation
3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Installation
4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Installation
5. CONNECT REAR SEAT OUTER BELT ASSEMBLY
(a) Connect the floor anchor end of the rear seat outer belt assembly and install the bolt.
Text in Illustration