Venza FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
When disconnecting the airbag connector, take care not to damage the airbag wire harness.
(d) Remove the 3 bolts and center airbag sensor assembly.
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION
1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Install the center airbag sensor assembly with the 3 bolts.
Text in Illustration
Torque : 18 Nm (178 kgf-cm, 13 ft-lbf)
NOTICE:
*
If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector,
replace it with a new one.
*
When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched
between other parts.
*
When the ignition switch is first turned to on after the center airbag sensor assembly has been replaced, make sure that no one is
in the vehicle.
(d) Connect the connector to the center airbag sensor assembly as shown in the illustration.