Venza FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
(2) Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.
(d) Remove the nut and rear airbag sensor.
NOTICE:
Loosen the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL REAR AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Insert the pin (stopper) into the body hole and install the rear airbag sensor with the nut.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)