Venza FWD V6-3.5L (2GR-FE) (2010)
SST : 09521-24010
(d) Tighten SST so that the No. 2 front axle inboard joint boot clamp is pinched.
NOTICE:
Do not overtighten SST.
(e) Using SST, measure the clearance of the No. 2 front axle inboard joint boot clamp.
SST : 09240-00020
Clearance:
0.5 to 1.5 mm (0.0197 to 0.0591 in.)
NOTICE:
If the measured value is greater than the specified value, retighten the clamp.
15. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING
(a) Install a new front drive shaft hole snap ring.
16. INSPECT FRONT DRIVE SHAFT ASSEMBLY LH See: Testing and Inspection/Component Tests and General Diagnostics