Yaris L4-1.5L (1NZ-FE) (2007)
i.
Remove the 3 bolts and the actuator with bracket.
6. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY
a. Remove the 2 nuts and the bracket.
INSTALLATION
1. INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY
a. Install the actuator bracket with the 2 nuts.
Torque: 5.4 Nm (55 kgf.cm, 48 in. lbs.)
NOTE: Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.
2. INSTALL BRAKE ACTUATOR
a. Provisionally install the 3 bolts onto the actuator bracket in the sequence shown in the illustration.
b. Tighten the 3 bolts in the sequence shown in the illustration.