Yaris L4-1.5L (1NZ-FE) (2007)
b. Install the skid control sensor onto the rear axle hub in the highest possible installation position.
HINT: The distance between the installation holes should be larger on the upper side than the lower side.
c. Using SST and a press, install a new skid control sensor into the rear axle hub until it is flush with the end.
SST 09214-76011
NOTE:
-
Do not use a hammer when installing.
-
Check for any foreign matter on the sensor probe.
-
Press the skid control sensor in slowly without turning it.
2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
3. INSPECT REAR AXLE HUB BEARING
4. CONNECT SKID CONTROL SENSOR WIRE
5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
6. ADJUST REAR DRUM BRAKE SHOE CLEARANCE
7. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf.cm, 76 ft. lbs.)
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf.cm, 48 in. lbs.)
9. CHECK ABS SENSOR SIGNAL