toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Procedures|Page 6862 > < Procedures|Page 6860
Page 49
background image

3. Disconnect the luggage compartment room light connector and remove the deck trim side panel.

14. REMOVE REAR SEAT SHOULDER BELT HANGER

a. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the rear seat shoulder belt hanger.

15. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY (for RH Side)

a. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the center belt guide.

16. REMOVE ROOF SIDE INNER GARNISH

a. for RH Side (w/ Curtain Shield Airbag):

NOTE:  Replace the special clip with a new one because it is damaged when the roof side inner garnish is removed.

1. Disengage the 5 clips.
2. Pass the rear seat outer and rear center seat outer belts through the slit in the roof side inner garnish and remove the roof side inner garnish.

Procedures|Page 6862 > < Procedures|Page 6860