Yaris L4-1.5L (1NZ-FE) (2007)
NOTE: Do not place the anchor plate over the convex area of the rear seat back frame.
b. for Hold Down Seat Type:
1. Install the rear center seat inner belt with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
NOTE:
-
Install the anchor plate with the arrow mark facing forward.
-
Do not place the anchor plate over the locating mark area of the floor panel.
2. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type)
3. INSTALL NO.2 REAR SEAT LEG COVER (for 60/40 Split Seat Type)
4. INSTALL NO.1 REAR SEAT LEG COVER (for 60/40 Split Seat Type)
5. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type)
6. INSTALL DECK FLOOR BOX (for 60/40 Split Seat Type)
HINT: Use the same procedure as for the RH side
7. INSTALL DECK BOARD SUB-ASSEMBLY (for 60/40 Split Seat Type)
8. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (for 60/40 Split Seat Type)
Rear Center Seat Outer Belt Assembly (For Sedan)