Yaris L4-1.5L (1NZ-FE) (2007)
/Page-1027004.png)
a. Remove the 2 screws and the commutator end frame, and hold down the lead wire while releasing the commutator end frame.
NOTE: To avoid interference between the brush holder and the dust protector, pull the commutator end frame away at an angle.
b. Using a screwdriver, hold the spring back and disconnect the brush holder.
c. Disconnect the 4 brushes, and remove the brush holder.
4. REMOVE STARTER ARMATURE ASSEMBLY
5. REMOVE STARTER CLUTCH SUB-ASSEMBLY
a. Remove the drive lever and starter clutch with shock absorber from starter housing.
b. Using a screwdriver, tap in the stop collar toward the starter clutch.
