Yaris L4-1.5L (1NZ-FE) (2007)
a. Using an ohmmeter, check the resistance between terminal C and the field coil brush lead.
Standard resistance: Below 1 Ohm
If the result is not as specified, replace the starter yoke assembly.
b. Using an ohmmeter, check the resistance between the brush lead and the starter yoke.
Standard resistance: 10 k ohms or higher
If the result is not as specified, replace the starter yoke assembly.
4. INSPECT BRUSH
a. Using vernier calipers, measure the brush length.
Standard length: 14 mm (0.5511 in.)
Minimum length: 9 mm (0.3543 in.)
If the length is less than the minimum, replace the starter brush holder assembly and the starter yoke assembly.