Yaris L4-1.5L (1NZ-FE) (2007)
1. DISPOSE OF FRONT SHOCK ABSORBER
(a)
Fully extend the shock absorber piston rod, and fix it at an angle in a vise or similar tool.
(b) Using a drill or similar tool, slowly make a hole in the area (A-B) shown in the illustration to discharge the gas inside.
NOTICE:
^
The gas is colorless, odorless and harmless.
^
Since the discharging gas may cause chips to scatter, cover the drill with a shop rag or piece of cloth when making the hole.
INSTALLATION
1. TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM
(a)
Provisionally tighten the lower arm with the 2 bolts.
(b) Install the lower arm onto the steering knuckle with a new castle nut.
Torque: 98 N*m (1,000 kgf*cm, 72 ft.*lbf)
NOTICE: If the holes for the clip are not aligned, tighten the nut by a further turn of up to 60°.
(c)
Install a new clip.
2. INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
3. STABILIZE SUSPENSION
(a)
Lower the vehicle from the jack.
(b) Bounce the vehicle up and down several times to stabilize the suspension.