Yaris L4-1.5L (1NZ-FE) (2007)
1. INSTALL FRONT DRIVE SHAFT DUST COVER
(a)
Using SST and a press, install a new dust cover into the inboard joint until it is flush with the end.
SST 09527-10011
NOTICE:
^
Install the dust cover in the correct orientation.
^
Do not deform the dust cover.
2. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING
(a)
Install a new snap ring.
3. INSTALL FRONT AXLE OUTBOARD JOINT BOOT
(a)
Wrap the spline of the outboard joint shaft with protective tape.
(b) Install new parts onto the outboard joint shaft in the following order.
(c)
Pack the outboard joint shaft joint portion and outboard joint boot with grease.
Standard Quantity: 125 to 135 g (4.4 to 4.8 oz.)
(d) Install the outboard joint boot onto the outboard joint shaft groove.
NOTICE: Keep the groove free of grease.
4. INSTALL FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP
CAUTION: Wear protective gloves to avoid injuries to your hands.
(a)
Install the boot clamp onto the outboard joint boot and provisionally bend the lever.
NOTICE:
^
Set the lever into the guide groove correctly.
^
Check the band and the lever for any deformation before bending the lever.
^
Set the lever into the guide groove correctly and install the clamp as far into the inner side of the vehicle as possible.