Yaris L4-1.5L (1NZ-FE) (2007)
Torque: 98 N*m (1,000 kgf*cm, 72 ft.*lbf)
NOTICE: If the holes for the clip are not aligned, tighten the nut by a further turn of up to 60°.
(b) Install a new clip.
6. INSTALL FRONT STABILIZER LINK ASSEMBLY
(a)
Install the stabilizer link with the nut.
Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf)
HINT: If the ball joint turns together with the nut, use a socket hexagon wrench 6 to hold the stud.
7. INSTALL TIE ROD END SUB-ASSEMBLY
(a)
Install the tie rod end onto the steering knuckle with a new castle nut.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
NOTICE: If the holes for the clip are not aligned, tighten the nut by a further turn of up to 60°.
(b) Install a new cotter pin.
8. INSTALL FRONT SPEED SENSOR (w/ ABS)
(a)
Install the speed sensor onto the steering knuckle with the bolt.
Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
NOTICE:
^
Check that the speed sensor tip and installation portion are free of foreign matter.
^
Install the speed sensor without turning it from its original installation angle.