Operational procedure
|
Paint stage
|
Products
|
Notes
|
|
I
|
II
|
III
|
|
|
Clean
|
x
|
x
|
x
|
Silicone remover
|
Spray on using pump atomiser and dry with highly absorbent
cloth.
|
Sand
|
x
|
x
|
x
|
Wet or dry sandpaper
|
Sand off area of fault. P600 grain wet or P240 grain dry
|
Putty application
|
x
|
–
|
x
|
Polyester fine putty, if required
|
Three to four layers of fine putty. Only apply fine putty to the
bare metal sheet.
|
Sand
|
x
|
–
–
|
x
|
Dry sandpaper
|
Only dry sand with polyester fine putty.
|
Clean
|
x
|
x
|
x
|
Silicone remover
|
Spray on using pump atomiser and dry with highly absorbent
cloth.
|
Apply filler
|
x
|
x
|
x
|
2-coat primer filler
|
Apply one to three layers of filler with a setting time of 3
minutes. Paint stage II includes minor repairs (no putty
application).
|
Sand
|
x
|
x
|
x
|
Wet or dry sandpaper
|
Grain no less than P1000. Sand in direction of travel. Grain no
less than P400.
|
Clean
|
x
|
x
|
x
|
Silicone remover
|
Spray on using pump atomiser and dry with highly absorbent
cloth.
|
Spray base paint
|
x
|
x
|
x
|
Top-2-coat metallic base coat
|
For 2/3 coat paintwork
1st base coat
Pre-spray one layer. Setting time 3 minutes.
Final spraying with one more layer.
For 3-coat perlitic
2nd effect layer coat:
Pre-spray one layer. Setting time 3 minutes.
Final spraying with one more layer.
For 2/3 coat paintwork
Apply in one spray action. Setting time 15
minutes before clear coat application.
|
Spray clear coat
|
x
|
x
|
x
|
2-C-MS clear coat - standard 2-C-HS clear coat - new
|
Pre-spray one layer. Setting time 3 to 5 minutes. Final spraying
with one more layer. Setting time 8 minutes prior to oven
drying.
|