Vauxhall Workshop Service and Repair Manuals

Set level regulation  

Notice: 

The vehicle may not be driven with maximum pressure in the empty condition. The minimum pressure of 80 kPa (0.8 bar) must be reached. With full loading the minimum pressure amounts to 300 kPa (3 bar).  
 

  Adjust   

Stand the vehicle without loading on a level surface. Fill the unit with 80 kPa (0,8 bar). At a point marked on the bodywork (e.g. the middle of the bumper), measure the height of the unladen vehicle rear. From this value deduct 50 mm and note the result. Following loading the pressure is to be increased far enough to reach the measurement (Height I-50 mm).     Important!    The pressure 500 kPa (5 bar) may not be exceeded.