Insert – Rear Lamp, Replace (Models F08,
F48)
Remove
Attaching parts, drill off rear lamp insert, bore out rivets and
separate adhesive surface.
Install
Fit rear lamp insert, drill holes for rivets (4 mm), special
waterproof rivets, part number 93174636, catalogue number 0188890,
deburr drilled holes. Prepare flange, apply spot weld paint, apply
adhesive (shaded area). Important: after adhesive application,
attach new part and weld immediately to the indicated weld
positions. Seal body seams. Seal cavities. Attaching parts.
|
|
|