|
Wheel Brake Cylinder, Remove and Install
Note: Repair or
overhaul of wheel brake cylinder is not envisaged for the time
being.
 Remove
|
Top up brake fluid reservoir to "MAX" mark and seal with
MKM-558-10.
Detach rear wheel.
Remove brake shoes – see operation "Brake Shoes –
Rear Wheel Brake, Remove and Install".
Unscrew brake line (2) – collect escaping brake fluid.
Seal apertures. Unscrew bolt (1) and remove wheel brake
cylinder.
Inspect
Check brake shoes – brake shoes which are soiled with
brake fluid must be replaced.
|
|
 Clean
Clean brake anchor plate and brake drum.
Install
Connect wheel brake cylinder to brake anchor plate –
tightening torque 9 Nm / 7 lbf. ft. Connect brake line to wheel
brake cylinder – tightening torque 16 Nm / 12 lbf. ft.
Install brake shoes – see operation "Brake Shoes –
Rear Wheel Brake, Remove and Install".
Inspect
Remove MKM-558-10 from brake fluid reservoir.
Bleed brake system and check for leaks – see operation
"Brake System, Bleed and Check for Leaks".
Correct brake fluid level up to mark "MAX".
Attach rear wheel – 110 Nm / 81 lbf. ft.
|
