|
Seal Ring – Camshaft, Replace
 Remove
Remove air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
Remove upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
For version with AC: Remove ribbed V-belts – see operation
"Ribbed V-belts, Remove and Install".
Remove V-belt – see operation "V-belt, Remove and
Install".
Remove lower part of toothed belt cover – see operation
"Toothed Belt Cover – Lower Part, Remove and Install".
Remove right engine damping block – see operation "Engine
Damping Block, Right, Remove and Install".
Remove toothed belt – see operation "Toothed Belt, Remove
and Install".
|
Remove camshaft pulley (2) from camshaft – counterhold
with open-ended spanner (1) at hex of camshaft.
Edge out seal ring (3) with suitable tool.
|
|
Install
Coat sealing lip of the new seal ring lightly with silicon
grease (white) and press into camshaft housing with KM-422 –
use bolt and washer of the camshaft pulley.
Camshaft pulley with new bolt to camshaft – observe
installation position of washer.
Caution
Hand tighten camshaft pulley – must still be possible to
rotate camshaft pulley on camshaft.
Install
Install toothed belt – see operation "Toothed Belt, Remove
and Install".
Install right engine damping block – see operation "Engine
Damping Block, Right, Remove and Install".
Install lower part of toothed belt cover – see operation
"Toothed Belt Cover – Lower Part, Remove and Install".
Install V-belt – see operation "V-belt, Remove and
Install".
For version with AC: Install ribbed V-belt – see operation
"Ribbed V-belt, Remove and Install".
Install upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
Install air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
|
