Engine Control Unit, Remove and Install
Note: For Y 20 DTH as
of MY 2003, Y 22 DTR the engine and injection pump control units
are a single unit and cannot be separated from the injection pump.
If a fault occurs the injection pump must be replaced - see
operation "Removing and installing injection pump".
Remove
Note: The security
code must be reset with TECH 2 before removal when replacing or
swapping engine control unit – see corresponding Checking
Procedures.
Remove front left wheel.
Remove wing inner protective panelling – see operation
"Wing Inner Protective Panelling, Remove and Install" in group
"A".
Detach wiring harness plug (3) and (4) from engine control
unit.
Remove engine control unit (2) from bracket (1).
|
|
Install
Install engine control unit in bracket.
Connect wiring harness plug to engine control unit.
Attach wing inner protective panelling – see operation
"Wing Inner Protective Panelling, Remove and Install" in group
"A".
Install front left wheel – tightening torque 110 Nm / 81
lbf. ft.
|