Oil Pressure, Check
Remove
Remove lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Detach wiring harness plug (1) from oil pressure switch.
Detach oil pressure switch (2) from cylinder block –
collect escaping engine oil.
Inspect
Check oil pressure with KM-498-B (3) and KM-135 (4). At idling
speed, the oil pressure should be approx. 150 kPa (1.5 bar) and the
oil temperature should be >= 80 °C.
|
|
Install
Attach oil pressure switch to cylinder block with new seal ring
– tightening torque 30 Nm / 22 lbf. ft.
Connect wiring harness plug to oil pressure switch.
Install lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Check engine oil level and correct if necessary.
|