Starter, Remove and Install
Remove
Remove air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
For version with AC: Remove ribbed V-belts – see operation
"Ribbed V-belts, Remove and Install".
Remove V-belt – see operation "V-belt, Remove and
Install".
For RHD vehicles: remove alternator – see operation
"Alternator, Remove and Install".
Remove exhaust manifold – see operation "Exhaust Manifold
(with Turbocharger), Remove and Install".
Remove exhaust manifold support (1).
Disconnect cable connections (2) from starter.
|
|
Remove lower starter fastening bolt (1) from cylinder block.
Remove upper starter fastening bolt (2) from starter.
Remove starter upwards.
Note: Check starter
– see operation "Starter, Check (Starter Installed)" or
"Starter, Check (Starter Removed and Disassembled)" (X 16 XEL
Engine) in group "J".
Disassemble and reassemble starter – see operation "Valeo
Starter, Disassemble and Reassemble" (X 16 XEL Engine) in group
"J".
|
|
Install
Insert starter and fasten.
Starter to cylinder block (transmission side, top) –
tightening torque 60 Nm / 44 lbf. ft.
Starter to cylinder block (engine side, bottom) –
tightening torque 45 Nm / 33 lbf. ft.
Attach cable connections to starter.
Attach exhaust manifold support to cylinder block.
Install exhaust manifold – see operation "Exhaust Manifold
(with Turbocharger), Remove and Install".
For RHD vehicles: install alternator – see operation
"Alternator, Remove and Install".
Install V-belt – see operation "V-belt, Remove and
Install".
For version with AC: Install ribbed V-belt – see operation
"Ribbed V-belt, Remove and Install".
Install air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
|