Bypass Valve, Replace
Remove
Remove right front wheel.
Remove lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Remove oil filter – see operation "Oil Filter,
Replace".
Remove thermostat housing (engine oil cooling) – see
operation " Thermostat Housing (Engine Oil Cooling), Remove and
Install".
Using tap (1) M10, 3rd stage – cut thread in closure disc.
Screw in M10 bolt and pull bypass valve out of seat.
|
|
Install
Drive in bypass valve to stop with drift (diameter approx. 15
mm).
Install thermostat housing (engine oil cooling) – see
operation " Thermostat Housing (Engine Oil Cooling), Remove and
Install".
Install oil filter – see operation "Oil Filter,
Replace".
Install lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Install wheel, front right – tightening torque 110 Nm / 81
lbf. ft.
|