|
Ribbed V-belt Tensioner Assembly, Remove and
Install
 Remove
Remove lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Mark running direction of ribbed V-belt. Relieve tension of
ribbed V-belt via ribbed V-belt tensioner and remove from tension
roller.
|
Remove fastening bolts (1) and (2) – remove ribbed V-belt
tensioner.
Remove damper (3) from tensioner – note installation
position.
|
|
Caution
Damper must only be stored upright. Incorrectly stored dampers
can be bled by compressing them several times in installation
position.
Install
Attach damper to tensioner – tightening torque 20 Nm / 15
lbf. ft.
Install ribbed V-belt tensioner on auxiliary aggregates main
bracket – tightening torque 42 Nm / 31 lbf. ft.
Attach damper to auxiliary aggregates support – tightening
torque 20 Nm / 15 lbf. ft.
Mount ribbed V-belt and tension ribbed V-belt via ribbed V-belt
tension roller. Ensure direction of travel and installation
position of ribbed V-belt are correct.
Install lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
|
