|
Toothed Belt Cover, Lower Part, Remove and
Install
 Remove
|
Remove air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
Remove upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
For version with AC: Remove ribbed V-belts – see operation
"Ribbed V-belts, Remove and Install".
Remove V-belt – see operation "V-belt, Remove and
Install".
Remove right front wheel.
Remove lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Remove torsional vibration damper (1) – counterhold on
fastening bolt of toothed belt drive gear.
Remove lower section of toothed belt cover (2) from rear toothed
belt cover.
|
|
Install
Attach lower part of toothed belt cover to rear toothed belt
cover – tightening torque 4 Nm / 3 lbf. ft.
Install torsional vibration damper – counterhold at
fastening bolt of toothed belt drive gear – tightening torque
– 20 Nm / 15 lbf. ft.
Install lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Install wheel, front right – tightening torque 110 Nm / 81
lbf. ft.
Install V-belt – see operation "V-belt, Remove and
Install".
For version with AC: Install ribbed V-belt – see operation
"Ribbed V-belt, Remove and Install".
Install upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
Install air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
|
