|
Toothed Belt Tension, Check
Note: This operation
only refers to run-in toothed belts.
For installation of a new toothed belt – see operation
"Toothed Belt Tension, Adjust".
Testing is performed with the engine cold – at room
temperature.
 Remove
Remove air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
Remove upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
For version with AC: Remove ribbed V-belts – see operation
"Ribbed V-belts, Remove and Install".
Remove V-belt – see operation "V-belt, Remove and
Install".
Remove lower part of toothed belt cover – see operation
"Toothed Belt Cover – Lower Part, Remove and Install".
 Adjust
|
At fastening bolt of toothed belt drive gear, turn crankshaft in
engine rotational direction to TDC – mark (1) on toothed belt
drive gear must align with mark (2) on the oil pump.
|
|
Inspect
The toothed belt tension is correctly adjusted when the pointer
(4) of the toothed belt tension roller is approx. 4 mm to the left
of the notch (3).
If the toothed belt tension is not correctly adjusted –
see operation "Toothed Belt Tension, Adjust".
Install
Install lower part of toothed belt cover – see operation
"Toothed Belt Cover – Lower Part, Remove and Install".
Install V-belt – see operation "V-belt, Remove and
Install".
For version with AC: Install ribbed V-belt – see operation
"Ribbed V-belt, Remove and Install".
Install upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
Install air cleaner housing with air intake hose and hot film
mass air flow meter – see illustration "Air Ducts".
|
