Timing, Check
Remove
Disconnect ground cable from battery.
Remove air cleaner housing – see illustration "Air Ducts X
14 XE, Z 14 XE, X 16 XEL,Z 16 XE, Z 16 YNG" or "Air Ducts X 18 XE1,
Z 18 XE, Z 18 XEL".
Remove upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
Inspect
At the fastening bolt of the toothed belt drive gear, turn the
crankshaft in the direction of engine rotation to "1st cylinder
ignition TDC" (mark 2). At the same time, the marks (1) on the
camshaft pulleys must be aligned (it must be possible to insert
Locking Tool KM-852 in this position).
Turn crankshaft slowly and smoothly.
If the timing marks do not align – see operation "Timing,
Adjust".
|
|
Install
Install upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
Install air cleaner housing – see illustration "Air Ducts
X 14 XE, Z 14 XE, X 16 XEL, Z 16 XE, Z 16 YNG" or "Air Ducts X 18
XE1, Z 18 XE, Z 18 XEL".
Connect ground cable to battery.
|