|
Immobiliser Control Unit, Remove and Install
|
Caution
The security code must be reset with TECH 2 before removing the
immobiliser control unit when replacing or swapping immobiliser
control unit – see corresponding Checking Procedures.
|
|
 Remove
Remove signal switch panelling – 5 fastening bolts
(arrows). Detach ignition key (3) and ignition lock trim (2).
|
Version I:
|
|
Release and disconnect wiring harness plug. Unclip and
disconnect immobiliser control unit (1) from ignition lock housing
(5).
|
|
Version II with catch lugs (arrow):
|
|
Remove lock cylinder (4) – see operation "Lock Cylinder
for Steering / Ignition Lock, Remove and Install" in group "N".
Detach immobiliser control unit from ignition lock housing.
National version: remove protective cap (6). Release wiring harness
plug and disconnect.
|
Install
|
Version I:
|
|
Attach immobiliser control unit to ignition lock housing.
Connect wiring harness plug.
|
|
Version II:
|
|
Connect wiring harness plug. National version: install
protective cap. Attach immobiliser control unit to ignition lock
housing. Install lock cylinder for steering / ignition lock.
|
Install signal switch panelling and
ignition lock trim.
- The ignition lock trim for Version I can only be used for this
version.
- The ignition lock trim for Version II can be used for Version I
and II.
|
|
|
