Camshaft, Remove and Install (Cylinder Head
Removed)
Remove
Remove DIS ignition module – see operation "DIS Ignition
Module, Remove and Install". Remove carrier plate from camshaft
housing – see operation "Seal Ring in Rear Camshaft Housing,
Replace". Remove pressure plate (1) from camshaft housing. Remove
camshaft from camshaft housing. Edge front seal ring out of
camshaft housing.
Clean
Clean sealing surfaces and remove gasket residues.
Inspect
Check camshaft housing for damage and wear – see operation
"Camshaft Housing for Plane Surface, Check". When replacing
camshaft, always replace all cam followers.
|
|
Install
Coat sliding surfaces of the camshaft with MoS 2 lubricating paste (grey), insert camshaft in camshaft
housing.
Install pressure plate on camshaft housing – 8 Nm / 6 lbf.
ft.
Lightly coat sealing lip of front seal ring with silicon grease
(white). Install new front seal ring with KM-422 in camshaft
housing – use bolt and washer of camshaft pulley.
Attach carrier plate to camshaft housing – see operation
"Seal Ring in Rear Camshaft Housing, Replace".
Attach DIS ignition module – see operation "DIS Ignition
Module, Remove and Install".
|