|
Toothed Belt Cover, Lower Part, Remove and
Install
 Remove
|
Remove air cleaner housing with air intake cover – see
illustration "Air Ducts (X 16 SZR)" and illustration "Air Ducts (Z
16 SE)".
Remove upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
Remove ribbed V-belts – see operation "Ribbed V-belts,
Remove and Install".
Remove ribbed V-belt tensioner – see operation "Ribbed
V-belt Tensioner, Remove and Install".
Lever closure plug (arrow) out of opening with screwdriver. Lock
drive disk or flywheel with KM-911 (1).
Detach torsional vibration damper (2) from crankshaft.
Remove fastening bolts (3) and remove lower part of toothed belt
cover from rear toothed belt cover.
|
|
Install
Attach lower part of toothed belt cover to rear toothed belt
cover – tightening torque 4 Nm / 3 lbf. ft.
Attach torsional vibration damper with new fastening bolt to
crankshaft – tightening torque 95 Nm / 70 lbf. ft. + 30°
+ 15°.
Remove Locking Tool KM-911 and insert new closure plug in
aperture.
Install ribbed V-belt tensioner – see operation "Ribbed
V-belt Tensioner, Remove and Install".
Install ribbed V-belt – see operation "Ribbed V-belt,
Remove and Install".
Install upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
Install air cleaner housing with air intake cover – see
illustration "Air Ducts (X 16 SZR)" and illustration "Air Ducts (Z
16 SE)".
|
