Insert housing with piston for multi-plate clutch C1 (1) in rear
cover.
Caution
When inserting in rear cover, ensure that the slotted seal rings
(x 4) do not get damaged.
Remove
Remove piston for multi-plate clutch C1 (2) – blow in low
pressure (arrow) compressed air. Use KM-994. Replace piston seal
rings (3 and 4) – coat with transmission fluid before
installation.
Inspect
Lock ball of piston for multi-plate clutch C1 – shake
piston (5) to check whether lock ball is movable. Check return
springs assembly for damage, and replace if necessary. Check
sliding surfaces of steel and lining plates for damage and wear,
and replace if necessary. New lining plates must be laid in
transmission fluid for at least 2 hours before installation.
|