|
Planetary Gear Set P1, Remove and Install (AF
20)
 Remove
Remove transmission – see operation "Transmission, Remove
and Install (AF 20)". Secure converter against falling out.
|
Attach transmission to KM-694-A (2). Attach assembly to KM-113-2
(1).
Remove fluid drain bolt (3), drain transmission fluid and
collect for damage diagnosis – see operation "Transmission
Fluid Condition, Check (AF 13-II/AF 17/AF 20/AF 22)".
Remove converter – see operation "Converter and/or Fluid
Pump Seal Ring, Replace (AF 13-II/AF 17/AF 20/AF 22)".
|
|
Remove rear cover with piston C1 – see operation "Rear
Cover with Piston C1, Remove and Install (AF 20)".
Remove drive shaft assembly with multi-plate clutch C1 and C2
– see operation "Drive Shaft Assembly with Multi-plate Clutch
C1 and C2, Remove and Install (AF 20)".
|
Remove race (1). Remove planetary gear set P1 (2) with sun gear
and thrust bearing (3) from transmission – note installation
position and condition of thrust bearing.
Install
Insert thrust bearing into transmission – note
installation position. Insert planetary gear set P1 with sun gear
into transmission. Insert race.
|
|
Measure
If installed correctly, dimension I (upper edge of sun gear to
upper edge of main housing) is: 18 mm.
Install
|
Install drive shaft assembly (1) with multi-plate clutch C1 and
C2 – see operation "Drive Shaft Assembly with Multi-plate
Clutch C1 and C2, Remove and Install (AF 20)".
Install rear cover with piston C1 – see operation "Rear
Cover with Piston C1, Remove and Install (AF 20)".
|
|
Install converter – see operation "Converter and/or Fluid
Pump Seal Ring, Replace (AF 13-II/AF 17/AF 20/AF 22)". Secure
converter against falling out.
|
Attach fluid drain bolt (3) with new seal ring to transmission
– tightening torque 40 Nm / 29.5 lbf. ft.
Remove transmission assembly from KM-113-2 (1) with KM-694-A.
Remove transmission from KM-694-A (2).
Install transmission – see operation "Transmission, Remove
and Install (AF 20)". Fill up transmission fluid
Inspect
Check and correct level of transmission fluid – see
operation "Transmission Fluid Level, Check and Correct (AF 13-II/AF
17/AF 20/AF 22)".
|
|
|
