|
Bearings for Main and Drive Shaft in Transmission
Housing, Remove and Install (F18)
Note: Transmission
remains installed.
 Remove
|
Remove gearshift cover (1) – see operation "Gearshift
Cover, Remove and Install and/or Seal (F13/F17/F17+/F18)".
Remove reversing lamps switch (2).
Remove end shield cover (3) – see operation "Gasket for
End Shield Cover, Replace (F13/F17/F17+/F18)".
Remove end shield (4) from transmission – see operation
"Gasket for End Shield, Replace (F13/F17/F17+/F18)".
|
|
Remove
Remove differential – see operation "Differential, Remove
and Install (F18)".
Disassemble
|
Pull needle bearing (3) for bearing of drive shaft out of
transmission with Counter Support KM-556-A (1) and MKM-599 (2).
Pull roller bearing outer race (4) for bearing of main shaft out
of transmission with KM-J-26941 (5), KM-483 (6) and KM-313 (7).
|
|
Assemble
|
Drive in flush new roller bearing outer race (3) for bearing of
main shaft into KM-743 (5) in conjunction with KM-J-8092 (4).
Drive in new needle bearing (2) for drive shaft bearing using
KM-523-2 (6) in conjunction with KM-523-1 (1) until flush.
Needle bearing side with writing points to transmission.
|
|
Install
Install differential – see operation "Differential, Remove
and Install (F18)".
Install
|
Insert end shield (1) into transmission – see operation
"Gasket for End Shield, Replace – F13/F17/F17+/F18".
Install end shield cover (2) – see operation "Gasket for
End Shield, Replace (F13/F17/F17+/F18)".
Install reversing lamps switch (4) with new seal ring –
tightening torque 20 Nm / 15 lbf. ft.
Install gearshift cover (3) – see operation "Gearshift
Cover, Remove, Install and/or Seal (F13/F17/F17+/F18)".
|
|
Inspect
Check transmission fluid level – see operation
"Transmission Fluid Level, Check and Correct
(F13/F17/F17+/F18)".
|
