|
Knob for Manual Shift Lever, Replace
(F13/F13+/F17/F17+/F18/F35)
 Remove
Remove shift layout insert for manual shift lever - see
operation "Shift Layout Insert for Manual Shift Lever, Remove and
Install (F13/F13+/F17/F17+/F18/F23/F35)".
Remove manual shift lever - see operation "Manual Shift Lever,
Remove and Install (F13/F13+/F17/F17+/F18/F35)".
Clamp gearshift lever with soft-wire protective jaws in
vice.
Place suitable op-ended spanner on shift knob and drive out
shift knob from shifter rod with rubber hammer – note
installation position and ensure that pressure spring below shift
knob does not jump off.
Install
|
Locate pressure spring on shift rod and drive new gear knob on
to shift rod using rubber mallet - note position of gear knob in
respect of shift rod. Fit manual shift lever - see operation
"Manual Shift Lever, Remove and Install
(F13/F13+/F17/F17+/F18/F35)". Fit shift layout insert - see
operation "Shift Layout Insert, Remove and Install
(F13/F13+/F17/F17+/F18/F23/F35)".
|
|
|
