Remove and install clutch master cylinder (RHD)
(F13/F13+/F17/F17+/F18/F23/F35)
Remove
Detach feed line (1) for clutch master cylinder from brake fluid
reservoir – collect brake fluid and close off aperture.
Release and remove connector clamp (2) with screwdriver. Detach
central release pressure line with damper from connector.
|
|
Remove
Footwell Panel – Driver's Side, Remove.
Detach return spring (5), slightly bend up lock tab (4) with
screwdriver and remove from pedal pin (3). Press out pedal pin (3).
Remove fastening nuts (2) and (6) from pedal bracket.
Remove clutch master cylinder (1).
|
|
Install
Insert clutch master cylinder in separation surface.
Install clutch master cylinder with new fastening nuts on pedal
bracket – tightening torque 20 Nm / 15 lbf. ft.
Guide pedal pin in clutch pedal and clutch master cylinder yoke
and secure with new lock tab. Attach return spring.
Install driver's side footwell panel.
Slightly bend retaining clamp together and insert in clutch
master cylinder. Press pressure line into clutch master cylinder
– engages audibly.
Connect feed hose to brake fluid reservoir.
Bleed hydraulic clutch actuation - see operation "Hydraulic
Clutch Actuation, Bleed (F13/F13+/F17/F17+/F18/F23/F35)".
|