Vauxhall Workshop Service and Repair Manuals

Remove gearshift cover (1) – see operation "Gearshift Cover, Remove and Install and/or Seal (F13/F17/F17+/F18)".

Remove reversing lamps switch (2).

Remove end shield cover (3) – see operation "Gasket for End Shield Cover, Replace (F13/F17/F17+/F18)".

Remove end shield (4) from transmission – see operation "Gasket for End Shield, Replace (F13/F17/F17+/F18)".

Pull needle bearing (3) for bearing of drive shaft out of transmission with KM-556-A (1) and MKM-599 (2).

Pull roller bearing (4) for bearing of main shaft out of transmission with KM-556-A (6) and KM-556-2 (5).

Important:   Do not drive roller bearing in until flush as this will damage the bearing.

Drive in new roller bearing (3) for main shaft bearing in transmission with KM-454-3 (5) in conjunction with KM-454-4 (4) as far as the stop.

Drive in flush new needle bearing (2) for bearing main shaft in transmission using KM-454-2 (6) in conjunction with KM-454-4 (1).

Needle bearing side with writing points to transmission.

  Install

Install differential – see operation "Differential, Remove and Install (F13)".

Insert end shield (1) into transmission – see operation "Gasket for End Shield, Replace – F13/F17/F17+/F18".

Install end shield cover (2) – see operation "Gasket for End Shield, Replace (F13/F17/F17+/F18)".

Install reversing lamps switch (4) with new seal ring – tightening torque 20 Nm / 15 lbf. ft.

Install gearshift cover (3) – see operation "Gearshift Cover, Remove and Install and/or Seal (F13/F17/F17+/F18)".

  Inspect

Check transmission fluid level – see operation "Transmission Fluid Level, Check and Correct (F13/F17/F17+/F18)".