Transmission Housing, Replace (F13)
Remove
Remove transmission – see operation "Transmission, Remove
and Install (F13/F17/F17+/F18)".
Attach KM-444-C to transmission.
Attach transmission with KM-444-C (1) to KM-113-2 (2).
Remove gearshift cover (5) with shift guide (6) – see
operation "Gearshift Cover, Remove and Install and/or Seal
(F13/F17/F17+/F18)".
Remove reversing lamps switch (4).
Remove end shield cover (3) – see operation "End Shield,
Remove and Install (F13/F17/F17+/F18)".
Remove end shield – see operation "Gasket for End Shield,
Replace – F13/F17/F17+/F18".
|
|
Remove
Remove differential – see operation "Differential, Remove
and Install (F13)".
Remove bearing for main (2) and drive shaft (1) in transmission
housing – see operation "Bearing for Main and Drive Shaft in
Transmission, Remove and Install (F13)".
Remove central release (5) - see operation "Central Release,
Remove and Install (F13/F17/F17+/F18/F23/F35)".
Remove pressure line from transmission housing (4) to central
release and fastening sleeve - pressure line (3) - see operation
"Pressure Line, Transmission Housing to Central Release and/or
Fastening Sleeve, Pressure Line, Replace
((F13/F17/F17+/F18/F23/F35)".
Remove transmission housing from KM-444-C.
|
|
Install
Attach new transmission housing to KM-444-C.
Install bearing for main (2) and drive shaft (1) in transmission
housing – see operation "Bearing for Main and Drive Shaft in
Transmission, Remove and Install (F13)".
Install pressure line from transmission housing (4) to central
release and fastening sleeve - pressure line (3) - see operation
"Pressure Line, Transmission Housing to Central Release and/or
Fastening Sleeve, Pressure Line, Replace
(F13/F17/F17+/F18/F23/F35)".
Install central release (5) - see operation "Central Release,
Remove and Install (F13/F17/F17+/F18/F23/F35)".
|
|
Install
Install differential – see operation "Differential, Remove
and Install (F13)".
Install end shield (1) – see operation "Gasket for End
Shield, Replace (F13/F17/F17+/F18)".
Install end shield cover (2) – see operation "End Shield
Cover, Remove and Install (F13/F17/F17+/F18)".
Install reversing lamps switch (4) with new seal ring –
tightening torque 20 Nm / 15 lbf. ft.
Install gearshift cover (3) – see operation "Gearshift
Cover, Remove and Install and/or Seal (F13/F17/F17+/F18)".
Remove transmission with KM-444-C from KM-113-2.
Remove KM-444-C from transmission.
Install transmission – see operation "Transmission, Remove
and Install (F13/F17/F17+/F18)".
|
|
|