Field Remedy: 2322
Subject: |
Window lifter - Noises and/or hard to
operate during opening and closing |
Models: |
Engines: |
Option: |
Astra-H 2008... |
All |
|
Complaint: |
Window lifter hard to operate with noises
during opening and closing. |
Cause: |
Position of window lifter in the door and
less grease in guide rail. |
Production: |
|
Remedy:
In case of a complaint the sash window has to be repositioned and the
guide rail of the window regulator has to be lubricated with grease.
Note: Carry out the following working instruction, do not replace
the window regulator.
1. Lower sash window.
2. Remove front door inner panelling
- see working procedure "Inner Panelling - Front Door, Remove and
Install", Group "C", Service Intruction Astra-H
(Document-Number 00501169 and 00901997).
3. Detach water vapour barrier
- remove 2x holding angles
4. Loosen front door sash window
- loosen 2x bolts (only 360 degree rotation)
Note: Guide the sash window in position so that the fastening bolts
align with the top mounting holes.
5. Guide sash window upwards (approx. 50 mm before window closed) and
place evenly in rubber seal.
Note: Sash window must abut parallel against inner edge of B-pillar
guide rail.
6. Fasten front door sash window
- tighten 2x bolts
7. Grease sliding surface of diagonal mounted guide rail
(see picture I,1) at its whole length
(grease partnumber: 90001825 / cataloguenumber: 19 48 524).
8. Fasten water vapour barrier
- install 2x holding angles
9. Attach front door inner panelling
- see working procedure "Inner Panelling - Front Door, Remove and
Install", Group "C", Service Intruction Astra-H
(Document-Number 00501169 and 00901997).
10. Close sash window.
FunctionalGroup: |
A - Body |
Complaint Group: |
13 - No/Poor Function,14 - Noises or
Vibrations |
Trouble Code: |
None |
|