|
Brake Fluid Reservoir, Replace (RHD)
 Remove
| 1. |
Detach cover of brake fluid reservoir
|
| 2. |
Siphon out as much brake fluid as possible with siphon
bottle
|
| 3. |
Unclip wiring harness from reservoir
|
| 4. |
Disconnect wiring harness plug (2) from brake fluid level
sensor
|
| 5. |
Detach brake fluid reservoir (1) from brake master cylinder
| • |
Remove brake fluid reservoir carefully from brake master
cylinder
Note: Collect brake
fluid and seal apertures
|
|
| 6. |
For vehicles with manual transmission: detach supply line for
clutch master cylinder from brake fluid reservoir
Note: Collect brake
fluid and seal apertures.
|
| 7. |
Detach brake fluid level sensor
|
|
|
Install
| 8. |
Replace seals (1) on brake master cylinder
Note: Do not use
mineral oils or greases when inserting seals (1) or when attaching
feed line for clutch master cylinder to brake fluid reservoir. If
necessary, brake cylinder paste should be used.
|
| 9. |
Attach brake fluid level sensor
|
| 10. |
For vehicles with manual transmission: Attach supply line for
clutch master cylinder to brake fluid reservoir.
|
| 11. |
Attach brake fluid reservoir to brake master cylinder
Note: Ensure brake
fluid reservoir is seated perfectly.
| • |
Attach brake fluid reservoir to brake master cylinder
|
|
| 12. |
Connect wiring harness plug to brake fluid level sensor
|
| 13. |
Clip wiring harness on at brake fluid reservoir
|
|
|
| 15. |
Top up brake fluid reservoir to "MAX" marking
|
| 16. |
Screw cover on to brake fluid reservoir
|
|
