Replace crankshaft seal ring (rear)
Remove
1. |
Remove thrust plate and clutch disk
|
2. |
Remove flywheel
• |
Block flywheel using KM-652 (1)
|
|
|
|
3. |
Remove rear crankshaft seal ring
Important: Do not damage sealing
surface.
|
• |
Prise out seal ring (1) with suitable tool
|
|
|
|
4. |
Install rear crankshaft seal ring
• |
Position KM-658-2 on crankshaft
journal
|
• |
Slide seal ring onto KM-658-2
|
• |
Drive in flush using KM-658-1 (1)
|
|
|
|
Install
5. |
Clean sealing surfaces.
|
7. |
Insert centring sleeve
|
9. |
Fit flywheel
• |
Block flywheel using KM-652 (1)
|
• |
Tighten 8x new bolt 29.4 Nm + 60° +
15°
1)
|
|
10. |
Install thrust plate and clutch disc
|
|
|
11. |
Check and correct engine oil level
• |
Observe specified engine oil quantity
|
|
1 ) Re-cut thread before re-use and insert bolt
with locking compound (red). The assembly time including the torque
test must not exceed 10 min.
|