Replace front toothed belt cover (top)
Remove
2. |
Remove engine cover (1)
• |
Pull off engine cover
Note: Re-attach any
retaining rubbers (2) to the engine cover which may have become
detached
|
|
|
|
3. |
Remove air cleaner housing (1)
• |
Disconnect mass air flow meter wiring harness (2)
– |
Unclip wiring harness from bracket
|
|
• |
Detach from air intake pipe
|
• |
Remove with water drain hose (4)
|
|
|
|
4. |
Remove toothed belt cover
• |
Unscrew 5x bolts (1) with EN-47631
|
|
|
|
Install
5. |
Install toothed belt cover
• |
Tighten 5x bolt (M6) 9 Nm
|
• |
Tighten 2x bolt (M8) 25 Nm
|
|
6. |
Install air cleaner housing
• |
Attach to air intake pipe
|
• |
Connect mass air flow sensor wiring harness
– |
Clip wiring harness into bracket
|
|
|
|