|
Radial Run-out of Crankshaft, Check
Note: Crankshaft
removed and only placed loose in cylinder block
 Remove
| 1. |
Detach cylinder block base plate
|
| 2. |
Measure radial run-out
| • |
Position dial gauge on central crankshaft journal
|
| • |
Measure radial run-out by turning the crankshaft
| – |
Permissible radial run-out 0.03 mm
|
|
|
|
|
Install
| 3. |
Apply silicone sealing compound
Note: The base plate
cylinder block must be fitted within 10 minutes of applying the
silicone sealing compound
Important: Do not lay bead of
silicone sealing compound in the groove or on the inner edge
|
| • |
Apply a bead of silicone sealing compound on the outside edge
of the groove (1) of the cylinder block base plate
| – |
approx 2 mm (dimension I) thick
|
|
|
|
|
| 4. |
Attach cylinder block base plate
| • |
Attach cylinder block base plate hand-tight to cylinder
block
|
| • |
Tighten 10x bolt M8 (inner) 25 Nm +
60°
|
| • |
Tighten 12x bolt outer (M6) 10 Nm +
60°
|
|
|
