|
Test
|
Work Order Description
|
Nominal Value
|
|
T001
|
Tester Display ECU Identification Data
|
- Ignition ON
- Engine OFF
- Press corresponding key in the system main menu to call up Additional Functions, select the desired test and confirm with ENTER . Follow the instructions in the diagnostic tester display.
Note:
This test can be used to monitor various different system specific data. These data are required for FLASH programming, in order to guarantee that the correct hard- and software versions are used. System specific data must be compared with the corresponding data on the newest TIS CD respectively.
|
Displayed value okay?
|
Concerned Terminals:
-
|
|
|
|
T002
|
Tester Display Display Immobiliser Status
|
- Ignition ON
- Press corresponding key in the system main menu to call up Additional Functions, select the desired test and confirm with ENTER . Follow the instructions in the diagnostic tester display.
- Check the following parameters for correct status:
Immobiliser function programmed.
|
YES
|
Concerned Terminals:
-
|
|
|
|
T003
|
Tester Display Engine Oil Status
|
- Ignition ON
- Engine OFF
- Press corresponding key in the system main menu to call up Additional Functions, select the desired test and confirm with ENTER . Follow the instructions in the diagnostic tester display.
Note:
This Additional Function can be used to show various different system specific data to determine the condition of the engine oil.
It is possible that the actual values change between the service inspections.
The given nominal values are only valid if the service interval has just been reset.
|
Displayed value:
INACTIVE
or
100
|
Concerned Terminals:
ECM: 21 (XC52)
|
|
|
|
T004
|
Tester Display ECM Odometer Value (Engine Control Module)
|
- Ignition ON
- Engine OFF
- Press corresponding key in the system main menu to call up Additional Functions, select the desired test and confirm with ENTER . Follow the instructions in the diagnostic tester display.
|
Displayed value okay?
|
Concerned Terminals:
-
|
|
|
